Telephone: +44 (0) 182 329 9390 or +44 (0) 330 223 1404 (9am - 4pm GMT)
Cart 0
SineTamer® Three-Phase Zoom

SineTamer® Three-Phase

SMP-36030

£ 1,650.00
Quantity
- +

SineTamer® can effectively remove the harmful effects of dirty electricity.

This leading suppression product which is the Standard of the Industry worldwide, is able to effectively solve the problems associated with effects of dirty electricity which is inherent in all our power today.

Not to be confused with "dirty electricity filters" and other suppression products on the market today.

The SineTamer® suppression product has been in existence for over 30 years, and is implemented in over 50
countries worldwide. Its primary focus has been for protecting the industrial and commercial buildings,
process equipment, as well as protecting sensitive electronics worldwide and allow the equipment to
operate as it was intended rather than succumb to equipment breakdown and costly downtime from failure
of operating systems.

It has been discovered that SineTamer® is able to effectively combat the problems associated with effects of dirty electricity and radio frequency. The special SineTamer® circuitry allows us to protect every mode of the power within our buildings, Line to Line, Line to Neutral, Line to Ground, and Neutral to Ground.

Thru our Special Frequency Attenuation Circuitry, we can closely follow the sinewave form, both above and below it to sense any deviation and quickly adjust to the excess energy, drastically reducing it thru our different modes of protection.

This special patented circuitry is not found in other suppression devices, and is what sets us apart from all others. The result of SineTamer® filtering, drops the RF levels to approximately 1.25 volts RMS constant. The SineTamer® suppression system is the safest, most effective and proven lowest let thru voltage of any suppression units in the world and is proud to be known as the Standard of the Industry. SineTamer® offers the longest, most unequalled warranty in the industry (15-25 yrs.) and offers proven results over time.

Installation is easy by a qualified electrician, as the unit is mounted and wired into the breaker panel immediately in line from the smartmeter at the building entrance. This will protect the internal circuits from all incoming dirty power and RF frequencies travelling into the building, as well as removing all transients which are induced from the house or building itself before they travel back to the smartmeter.

Updatting...

Related Products