Call us:UK (Working hours: 9am - 4pm): +44 (0) 182 329 9390 or +44 (0) 330 223 1404    USA: +1 405 279 3167
Cart 0
90cm wide 0.3mm Stainless Steel Shielding Mesh Zoom

0.3mm Stainless Steel Shielding Mesh- 90cm wide (By Meter)

EMY-35132

Available

£ 12.95
Quantity
- +

This product is not sold individually. You must select at least 5 quantity for this product.

Stainless Steel 0.3 mm Shielding Mesh - 90cm Wide (By Linear Meter)

Finely woven, noncorrosive stainless-steel gauze for the protection against high-frequency radiation (HF) and low-frequency electric fields (LF).

Typical application for exterior and or interior under-plaster in upgraded insulations, in roof areas, at drywall constructions, as a flyscreen.

Technical data

Width: 90 cm

Length: by the linear meter

Attenuation: 55 dB at 1 GHz (two-layer 75 dB)

Mesh width: 0.3 mm

Wire diameter: 0.08 mm

Material thickness: 0.16 mm

Open area: 54 %

Weight: 200 g/m²

Color: Silver

Fire-proof material, A1 according DIN 4102:1994

Surface conductivity: 0.03 Ohm (square resistance)

 

Grounding

Due to the highly conductive surface this material can be contacted and grounded easily to shield low frequency (LF) electric fields. For grounding use our Stainless Steel Grounding Tape.

 

EMF Shielding Attenuation

The shielding attenuation is regularly tested in our partner laboratory in Munich to the standards ASTM D4935-10 and/or IEEE-STD-299-2006. The line in the diagram stands for the radial direction of polarisation (both directions, horizontal/vertical) and indicates the attenuation achievable in practice. You find the test report below.

Stainless steel mesh 0.3mm for shielding

Download EMF Shielding Test Report 

 

Wire Mesh Installation

For installing under plaster, preferably use a fine and organic filler.

For under-floor covering (laminate, parquet, PVC coating, etc.) the mesh should be fixed with the same adhesive used for the floor covering.

For drywall construction or roof areas the mesh elements can be bolted or stapled together.

Always overlap the single elements by a minimum of 5 cm (2”).

Always ground the wire mesh installation using the following grounding products; screwing it right across the elements into the surface.

https://emfclothing.com/en/grounding/320-grounding-set-for-mcl61.html

https://emfclothing.com/en/grounding/329-stainless-steel-grounding-tape-for-wire-mesh-10m-roll.html

Ensure minimum 5mm (0.2”) clearance around all electrical sockets and fittings.

Updatting...

Related Products